Eureka AS1092A Use and Care Manual download pdf (Page 8)

Eureka Customer Service HELPLINE 1-800-282-2886

www.eureka.com

Problem solving

Make sure vacuum is turned off and power cord is unplugged.

Motor will not start.

Vacuum does not clean

carpet or bare floor.

No suction at the

end of hose.

Turbo nozzle will not turn

(on some models).

Vacuum is hard

to push.

Burning smell; brush roll

will not turn.

Cord will not rewind fully.

Cause

Solution

Power plug

• Push plug securely into outlet, try another outlet or

check circuit breaker.

Power switch • Step on power switch to turn vacuum on.

Thermal cut-off • See detailed "thermal cut-off" instructions above.

Dust cup and filter

• Empty dust cup, clean and/or change filter.

• Clean or replace filters regularly to maintain suction. Page 2

• If picking up fine dust, the dust cup may not look full, but a fine substance

tends to reduce suction when it blocks air flow through the filter and screen.

Refer to page 2 for filter maintenance. Make sure filter, screen and dust cup

are installed properly.

Air path selector • Turn selector knob to ‘floors.’

Belt • Replace a worn, cut or out of shape belt. Page 4

Hose • Remove clogs from the hose that restrict the airflow. Make sure hose

is replaced into hose retainer. Page 4

Bare floor setting

• For bare floor cleaning, turn height adjustment knob

to bare floor position. Step on brushroll on/off pedal to

turn off the brushroll.

Carpet height setting

•

For carpet cleaning, step on the brushroll on/off pedal to ensure the brushroll

is on. Adjust height adjustment knob to appropriate carpet height setting.

Dust cup and filter

• Empty dust cup, clean and/or change filter.

• Clean or replace filters regularly to maintain suction. Page 2

• If picking up fine dust, the dust cup may not look full, but a fine substance

tends to reduce suction when it blocks air flow through the filter and screen.

Refer to page 2 for filter maintenance. Make sure filter, screen and dust cup

are installed properly.

Air path selector • Turn selector knob to ‘tools.’

Hose

• Remove clogs from the hose that restrict the airflow. Make sure hose

is replaced into hose retainer. Page 4

Rotating brush • Check turbo nozzle for debris. Page 5

• If no suction at end of hose, turn selector knob to ‘tools.’

Vacuum height setting • Adjust knob to a higher position.

Belt • Replace a worn, cut or out of shape belt. Page 4

Belt • Check brush roll for debris. Page 4

• Replace broken or out of shape belt. Page 4

Cord tangles • Pull out entire cord removing any kinks, and push button to rewind

completely.

Problem

N O T I C E: Thermal cut-off

This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, proceed as follows:

1) Push the power switch to off and unplug the vacuum.

2) Check the vacuum for a possible source of overheating such as a full dust cup, blocked hose or clogged filter. If these conditions are found, fix them

and wait at least 30 minutes before attempting to use the vacuum.

3) After the 30 minute period, plug the vacuum back in and turn on the switch. If the vacuum still does not work, call the Eureka customer service helpline.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Eureka AS1092A Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Vacuum cleaners Eureka AS1092A