2
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
How to identify parts of vacuum cleaner
W belt
Brush roll
Handle
Turbo nozzle
(on some models)
Dust cup release
Filter assembly
(located inside dust cup)
Dust cup
Exhaust/HEPA
filter compartment
(located behind dust cup)
Brushroll on/off pedal
Brush roll cover
Cord clip
Carry handle
Wand
Lower hose retainer
Base hose
Maintenance schedule
Maintenance Schedule is also located on back side of dust cup.
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Moving parts! Power switch is marked for On/Off.
I
Air path
selector knob
Cord rewind switch
Power switch
Handle release
Crevice tool
Dusting brush
Hose
SPECIAL FEATURES
Available on some models
Turbo cover
Wand 2
Power cord
Cord reel
Turbo
nozzle
DUST CUP – Empty after each use
Close bottom lid
until it clicks.
Press lever to release bottom lid.
Debris will empty.
BRUSH ROLL – Clean monthly
W BELT –
Replace worn, cut or out of shape belt
Remove dust cup. Press down tab and
remove filter cover.
Lift out filter and replace. Reinstall
cover and snap into place.
( HEPA filter
on some models)
Exhaust filter
EF6
EXHAUST FILTER EF6 – Check filter regularly. Replace every
6-12 months or when performance loss is noticeably declining
Height
adjustment knob
Washable
Washable filter
DCF-25
Filter
assembly
Washable dust cup filter DCF25 Clean
as needed to maintain suction.
Pull filter latch to release dust cup cover. Lift out
cup filter. Wash filter; allow to air dry thoroughly.
Lift out filter tube and screen. Shake off
dust. Rinse; dry thoroughly.
Close cover.
Filters and screen must be in
place for cover to lock.
Align tabs on filter tube, screen and cup;
drop into position. Reinstall cup filter.
Comments to this Manuals